Connecting the world to reliable power

Engineering

The scheme behind the machine

A machine that is the right size can still be the wrong answer if the arrangement around it has not been designed. This is the technical assessment we run before anything is quoted, and what comes out of it.

Why a machine is not a scheme

A genset alternator is specified by conditions. The size follows from the load, but the load does not decide on its own how the field is supplied, how the machine behaves under a fault, or how it is fixed to the engine. Those decisions belong to the installation, not to the catalogue.

Most of the quotations that come back wrong were not wrong about the power. They were wrong about the arrangement around it, and the error only showed up when the machine was standing next to the engine.

So the assessment comes before the quotation. We look at what the set is for, what the load does, how the machine will be paralleled, what the protection has to withstand, and what the local grid requires, and we write the answer down.

Alternator on an inspection bench during technical review
Alternator on the inspection bench during engineering review
Placeholder - to be replaced with our own photography

What we assess

Five things, and each of them changes the machine rather than the price.

Load behaviour

What the load actually does: steady, or stepping, and how much of it is electronic. A load that steps hard and a load that draws harmonics are different problems for the same machine.

Parallel operation

How many machines share the board, how they share the load, and whether the protection has to discriminate between circuits. This is what decides the excitation arrangement, and it cannot be left to a default.

Grid standard

The voltage, the frequency and the local requirements the installation has to satisfy, because they are what the machine is built against.

Thermal environment

The ambient temperature and the altitude, which set the rating basis and therefore the size of the machine that can actually be installed.

Mechanical interface

Whether the engine carries the machine on its housing flange or the machine runs on its own bearings, and the dimensions that have to match.

What comes out of it

A selection scheme: the machine rating in kVA confirmed separately from the running load in kW, the frequency and voltage arrangement, the mounting interface, the excitation arrangement and the protection requirement, with the reasoning behind each one written next to it. Where a condition is still open, the scheme says so instead of choosing for you.

That document is what the order is placed against, and what the factory works to. It is also what you receive, so if a question comes up later there is a written answer to point at rather than a memory of a conversation.

How fast it comes

An enquiry is answered within 24 hours, and the selection scheme within 48. For the harder cases - machines in parallel, heavily non-linear load, low-speed duty - the first reply says what is confirmed and what is still open, so the clock does not restart silently in the middle of the project.

Next step

Send the conditions and we will work through them

Send the load, the duty, the frequency and the site conditions. We will come back with the scheme, the questions that are still open, and a quotation against it.

Chat on WhatsApp Business

Ask us

Answers come from published selection notes, not from a catalogue.

Request a quotation

We reply to every enquiry within 24 hours, and a selection scheme follows within 48.