Dust and corrosion

Dust and corrosive gas get inside a machine that was not built for them, and the failure comes later rather than sooner. The protection arrangement is decided with the site in mind.

How the machine is configured against this condition

Open mines, cement plants
Dust and corrosion
English nameDusty and Corrosive Environment
Core problemDust, corrosive fumes and chemical gases enter the machine, so the insulation ages, dust packs the ventilation path, cooling is blocked and the failure rate rises while the service life falls.
SolutionThe machine is sealed and its insulation treated against corrosion, the stator and rotor are reinforced against dust and damp, a separate filtered air intake is added where it is needed, and the terminal box and the cable entry are sealed off so dust and corrosive media stay out.
Typical applicationsOpen mines, cement plants, lime kilns, chemical parks, foundries and dusty outdoor work sites.
Selection points
  • Raise the protection rating to match the dust and corrosion on site: IP23 / IP44 or a dust shield where it is needed.
  • Windings treated for damp and corrosion resistance.
  • Shorten the service interval and fit replaceable dust filter parts.
  • Say how the machine will be cleaned on site, and how often.

Where to go next

What we can supply

Protection arrangements are inside the range.

Open pits and underground work

Open pits, and dust that gets into everything.

Explosion-proof and non-sparking

A machine built so that it cannot be the source of the ignition.

Choose the power band

Protection arrangements differ across the range.

Chat on WhatsApp Business

Ask us

Answers come from published selection notes, not from a catalogue.

Request a quotation

We reply to every enquiry within 24 hours, and a selection scheme follows within 48.